Product Overview
The product photographs used below show D4N-1162 on the physical label. Five distinct views support comparison of the roller arm, nameplate, mounting slots, terminal housing and bottom conduit entry. A separate manufacturer page used a D4N-1A62 representative photograph; that conflicting image is not used here.
FRONT LABEL AND ROLLER-ARM VIEW
BOTTOM Pg13.5 CONDUIT ENTRY
FRONT LABEL AND MOUNTING SLOTS
REAR HOUSING AND TERMINAL MARKING
CONDUIT-ENTRY FACE
Specification Confirmation
| Item | Reviewed exact-model reference | Order check |
|---|
| Model | D4N-1162 | Match the complete physical label |
| Actuator | Horizontal one-way roller arm lever | Confirm travel direction, roller position and cam geometry |
| Contacts | 1 NC + 1 NO | Verify terminal assignment and required control logic |
| Switching action | Snap action | Do not substitute the D4N-1A62 slow-action variant |
| Connection | Terminal block | Confirm conductor size, terminals and wiring method |
| Conduit entry | One bottom entry, Pg13.5 | Confirm thread, gland, cable diameter and sealing |
| Housing | Plastic | Check mounting and environmental compatibility |
| Contact finish | Gold clad, 3 µm | Confirm suitability for the actual control circuit |
| Label load references | AC-15: 3 A / 240 VAC; DC-13: 0.27 A / 250 VDC | Confirm actual load, inrush and protective device |
| Degree of protection | IP67 reference | Depends on complete installed sealing |
| Distributor dimension reference | 31 × 31.5 × 83.6 mm | Measure actual unit and confirm current drawing |
| Ambient temperature reference | −30 to +70 °C | Confirm actual site conditions |
| Mechanical-life reference | 15,000,000 operations | Actual life depends on alignment, travel and duty |
Technical values are retained as exact-model or label references, but they do not establish the origin, condition or traceability of the supplied stock. Verify the physical unit and current documentation before use.
Functional Highlights
One-way roller actuation
The horizontal roller arm is intended for actuation from the specified direction. Confirm cam approach, overtravel and release path.
Snap-action contacts
The D4N-1162 reference identifies snap action with 1 NC + 1 NO contacts. Do not replace it with the similarly named D4N-1A62 slow-action version.
Bottom conduit entry
The one-conduit housing uses a bottom Pg13.5 entry. Match the gland thread and installed sealing components.
Buyer Confirmation Checklist
Actuator and mounting
Check horizontal one-way roller orientation, operating position, travel, overtravel, release force, mounting slots and available clearance.
Contacts and load
Verify 1 NC + 1 NO snap action, terminal assignment, voltage, utilization category, load current and inrush.
Supplied-unit evidence
Request the actual D4N-1162 nameplate, terminal block, conduit thread and traceability documents when manufacturer origin or certification matters.
Frequently Asked Questions
Is D4N-1162 interchangeable with D4N-1A62?
No. The reviewed references identify D4N-1162 as snap action and D4N-1A62 as a different slow-action variant.
Can the switch be selected from the housing shape?
No. Match the complete model, roller direction, contact action, terminal arrangement, conduit entry and mounting dimensions.
Does the published IP67 reference guarantee the installed result?
No. The final protection level depends on the gland, cable, sealing, mounting and condition of the actual unit.
Selection note: Confirm the D4N-1162 physical label, one-way roller direction, snap-action contacts, Pg13.5 entry, mounting and actual circuit load before ordering or replacement.
