+86 021-57676786 News Center Careers
Home / FAQ / What does an elevator automatic rescue device do during a power failure?
← Back to FAQ list

What does an elevator automatic rescue device do during a power failure?

Ask Time: 2024-05-29
Answer
A supported rescue system uses stored energy to perform a defined recovery operation, commonly moving the car to a suitable landing and enabling door opening. The exact behavior depends on the elevator and device design. Confirm the supported rescue sequence for the proposed installation.
Answer Time: 2024-05-30

Derived Questions

Can an emergency leveling device be added to an existing elevator inverter?
Only if the inverter and controller support the proposed rescue arrangement. Check motor, brake, door power and safety interfaces together. An add-on device cannot be approved from the motor power alone, so request an integration review for the exact equipment.
Ask Time: 2024-05-31 Answer Time: 2024-06-01
Is an elevator automatic rescue device the same as a building UPS?
No. A rescue device is designed around a specific elevator recovery sequence and its interfaces. A building UPS provides power for its specified loads but does not by itself manage elevator rescue. The power and control design must be evaluated as a complete system.
Ask Time: 2024-06-01 Answer Time: 2024-06-01
Why does an elevator rescue device power up but fail to move the car?
Battery condition, an unsupported drive interface, brake or safety-circuit status and configuration can prevent rescue operation. Record indicators and fault information for a qualified engineer. Repeated attempts or bypassing interlocks should not replace diagnosis using the system documentation.
Ask Time: 2024-06-02 Answer Time: 2024-06-02
How do I specify batteries for an elevator emergency leveling system?
Use the rescue unit's approved battery type, voltage arrangement, capacity and charging requirements. Include temperature, maintenance access and required performance. Do not substitute batteries solely because their voltage matches. The supplier should confirm the complete battery configuration for the selected device.
Ask Time: 2024-06-01 Answer Time: 2024-06-01
What should be demonstrated when commissioning an elevator emergency rescue device?
The commissioning plan should verify the documented outage sequence, power transfer, controlled movement, landing detection and door operation, as applicable to the design. Include battery and fault-monitoring checks. Qualified personnel should record results using the manufacturer and project procedures.
Ask Time: 2024-06-02 Answer Time: 2024-06-02