+86 021-57676786 News Center Careers
Home / FAQ / How do I specify an elevator traveling cable for a modernization project?
← Back to FAQ list

How do I specify an elevator traveling cable for a modernization project?

Ask Time: 2024-08-04
Answer
Prepare a circuit schedule covering power, control, communication and spare conductors. Include travel height, suspension arrangement, movement envelope and environmental conditions. The cable supplier should confirm conductor construction, shielding and mechanical suitability for the installation, including the required support system.
Answer Time: 2024-08-04

Derived Questions

What documents should I request with elevator traveling cable for an overseas project?
Request the conductor schedule, electrical ratings, dimensional drawing, bending and suspension guidance, and product-specific compliance documents required by the project. Confirm cut-length identification and test documentation in the order. General cable-family literature may not describe the supplied construction.
Ask Time: 2024-08-09 Answer Time: 2024-08-10
Can an elevator traveling cable carry CCTV and control signals together?
A purpose-designed cable may combine different circuits, but signal performance depends on its construction and system requirements. Specify the video or data interface, cable length and electromagnetic environment. Confirm separation, shielding and electrical ratings rather than assuming spare conductors can carry any signal.
Ask Time: 2024-08-05 Answer Time: 2024-08-06
How much extra length should I allow when ordering elevator traveling cable?
Use the surveyed route, hanging-loop geometry, termination positions and manufacturer's installation allowances. Travel height alone is not the cut length. Ask the installer to approve a cable schedule showing each required length before ordering, particularly where factory termination or special support members are involved.
Ask Time: 2024-08-06 Answer Time: 2024-08-07
What is the difference between flat and round elevator traveling cables?
They differ in physical arrangement, bending behavior and suspension requirements. The shaft layout, available loop space and support system influence the choice. A replacement must suit the existing movement envelope and documented installation method, not just provide the same number of cores.
Ask Time: 2024-08-06 Answer Time: 2024-08-06
Why does an elevator lose communication only at certain floors?
A moving cable fault is one possible cause, alongside connectors, shielding and other communication problems. Correlate fault logs with car position and inspect the relevant circuit using the maintenance procedure. Do not replace the full traveling cable solely on a position-related symptom without confirming the cause.
Ask Time: 2024-08-08 Answer Time: 2024-08-08