+86 021-57676786 News Center Careers
Home / FAQ / Can I replace an elevator landing door panel without replacing the full entrance?
← Back to FAQ list

Can I replace an elevator landing door panel without replacing the full entrance?

Ask Time: 2024-11-09
Answer
Only if the replacement is suitable for the existing hanger, sill, lock and entrance construction. Check panel dimensions, mass and interfaces. Where fire performance is required, confirm that the replacement preserves the documented entrance assembly rather than assuming panel appearance is sufficient.
Answer Time: 2024-11-09

Derived Questions

Why does a new elevator landing door panel rub against the sill?
Incorrect dimensions, guide-shoe position, hanger adjustment or existing sill damage can cause interference. A door technician should inspect the complete entrance and compare it with the installation drawing. Do not remove material from the panel or sill without an approved repair method.
Ask Time: 2024-11-13 Answer Time: 2024-11-13
Can I change the finish of a fire-rated elevator landing door?
A finish change must be checked against the approved door assembly and permitted modifications. Added cladding can affect mass, clearances and documented fire performance. Obtain confirmation for the exact material and attachment method before ordering decorative panels.
Ask Time: 2024-11-12 Answer Time: 2024-11-12
What should a fire-rated elevator landing door quotation clearly identify?
Request the door assembly or panel scope, exact model, dimensions, required fire classification and supporting documentation. Confirm the installation conditions covered by those documents. Avoid accepting an unspecified fireproof claim as a substitute for evidence tied to the supplied configuration.
Ask Time: 2024-11-13 Answer Time: 2024-11-14
What measurements are needed for a replacement elevator landing door leaf?
Provide panel height, width, thickness, handing, hanger fixings and bottom guide arrangement. Include opening type, sill details and the original door-system reference. Record overlap and interface geometry from approved drawings where available, since worn parts may not reflect the intended dimensions.
Ask Time: 2024-11-11 Answer Time: 2024-11-11
Does a stainless steel elevator door panel automatically have a fire rating?
No. Fire performance depends on a tested or otherwise accepted door assembly and its installation conditions. Stainless steel facing alone does not establish a rating. Request documentation for the exact proposed entrance configuration and the project's required performance.
Ask Time: 2024-11-09 Answer Time: 2024-11-10