+86 021-57676786 News Center Careers
Home / FAQ / How do I choose a replacement elevator floor display for an existing controller?
← Back to FAQ list

How do I choose a replacement elevator floor display for an existing controller?

Ask Time: 2024-08-21
Answer
Start with the display board code and controller model, then compare the communication protocol, supply voltage, connector pinout and mounting drawing. A matching screen size or plug does not establish compatibility. Include the current floor labels and orientation in the replacement specification.
Answer Time: 2024-08-22

Derived Questions

Which spare elevator display boards should a maintenance company keep in stock?
Group installed displays by exact board code, hardware revision, protocol and mounting format. Prioritize frequently used variants and units with longer replacement lead times. Record configuration requirements beside each spare, because a visually identical board may need different settings or may belong to another controller family.
Ask Time: 2024-08-26 Answer Time: 2024-08-26
Why does an elevator floor indicator show the wrong floor after replacement?
Incorrect floor mapping, board addressing, protocol settings or configuration can cause this symptom. A service engineer should compare the new display setup with the controller documentation and recorded original settings. If several indicators show the same error, investigate the shared control signal before replacing individual screens.
Ask Time: 2024-08-22 Answer Time: 2024-08-23
Can an elevator display show basement floors and custom floor names?
This depends on the display character set and how its controller assigns floor codes. Specify labels such as B2, G or M in a floor schedule rather than assuming they are supported. Ask for confirmation of the exact character mapping and display orientation before approving the board.
Ask Time: 2024-08-25 Answer Time: 2024-08-26
Can I replace an elevator dot matrix indicator with an LCD display?
An LCD upgrade is possible only when its interface and software support the installed control system. Check panel cutout, viewing area, power requirements and available depth. A controller interface or panel modification may be needed, so obtain an agreed wiring and installation proposal before ordering.
Ask Time: 2024-08-22 Answer Time: 2024-08-22
What information should an elevator display RFQ include for a modernization project?
Send ZH-ENG the controller and display labels, front and rear photos, cutout dimensions, mounting-hole positions and required floor characters. State the quantity for car and landing locations separately. Request confirmation of the proposed interface, included cables and any configuration work in the quotation.
Ask Time: 2024-08-23 Answer Time: 2024-08-24